1 |
Select for 3rd party seal attachment. |
2 |
Not applicable for Output Signal code -F. |
3 |
Not applicable for Electrical Connection code 0, 5, 7, 9 or A. |
4 |
Applicable for Electrical Connection code 2, 4, 7, 9, C, and D. |
5 |
Not applicable for option code /AL. |
6 |
Not applicable for Output Signal code -F. |
7 |
See the "Ordering Information" section of the appropiate GS. |
8 |
Applicable Wetted Parts Material code S. |
9 |
Not applicable with Amplifier Housing code 2. |
10 |
Consult Factory for the correct use of this option. Applicable to Measuremnet Span code D. If compliance with Category III is needed, specify this option code. |
11 |
316 or 316L SS. This specification is included in Amplifer Housing code 2. |
12 |
Limited to 16 Characters Maximum. Must be special ordered if more digits are required. |
13 |
Note not used. |
14 |
Applicable for Electrical Connection code 2, 4, 7, 9, C, and D. |
15 |
Applicable for Output Signal code -F. |
16 |
Tokuchu approval is required before an order for this option can be accepted. |
17 |
Note not used. |
18 |
Note not used. |
19 |
Not applicable for combination of Measurement Span code D and Wetted Parts Material code H. |
20 |
Material of a blind plug is aluminum alloy or 304 SST. |
21 |
Defines unit of measure used for the MWP on the data plate. If no code is selected, MWP will be expressed in MPa. |
22 |
Note applicable for Option code /FF1. |
23 |
Not applicable for Amplifier Housing code 2 |
24 |
Not applicable for electrical connection codes 0, 2, and 4. |
25 |
Applicable for capsule code B. |